CU-DIN R 4-CH 16 A KNX
CU-DIN R 8-CH 16 A KNX
44 / 54
CU-DIN R 12-CH 16 A KNX
USER MANUAL
Operation of switch after bus voltage recovery
There are four options for bus voltage recovery as below.
Options:
Unchange
Recovery
ON
OFF
Unchange: The channel switch position will be unchanged after bus voltage
recovery.
Recovery: After bus voltage recovery, the channel switch position will revert its
state previous to the power-down.
ON: The channel switch position will be set to ON after bus voltage recovery.
OFF: The channel switch position will be set to OFF after bus voltage recovery.
Save statistic for ON switching `counter (4bytes)`
Statistical channel switch ON counter.
Options:
Disable
Enable
Disable: Disable statistics ON counter.
Enable: Enable statistics ON counter.
PWM cycle time set (1–65,535 min)
Options:
1–65 535 min
The minimum cycle time is 1 minute.
PWM cycle time set (0–59 sec)
Options:
0–59 s
This cycle time is set in seconds.
Control telegram is received as
Type of control can be 1 bit or 1 byte.
Options:
1 bit PWM (1-start/0-stop)
1 byte (255-switch ON/0-switch OFF/Other valve)
1 bit PWM (1-start/0-stop): The PWM is switched ON when the receiving telegram
value is “1”, and stopped by “0”.
1 byte (255-ON/0-OFF/Other valve): Always switched ON by receiving telegram
value “255”, and switched OFF by receiving telegram value “0”. The PWM runs
and pulse width of PWM is set according to the value of receiving telegram (1 to
254).
Transmit status response object "Telegram: status heating"
There are three options for the channel state response setting.
Options:
No response
Always respond
Only after changed