1 General information
1.4 Procedure with the used equipment
The electronic device was made from materials, which are good for recycling only in part. That is
why, the device must be returned to the recovery and recycling place of electrical and electronic
equipment or handed over to the manufacturer. The device must not be disposed of with other household
rubbish.
2 Connecting to the system
2.1 Electrical wiring
Before you start to operate the device, read the whole attached user`s guide carefully.
The person who carries out the installation must have technical experience.
Connections made with the copper cable should be adapted to the operation at a temperature of up to
+75ºC.
All the connections must be compatible with the installation electrical wiring diagram and national
or local regulations about electrical connections.
2.2 Location
The device is intended for the installation only in enclosed spaces.
After choosing the place of installation, make sure it meets the following conditions:
1. The installation place must be free of excessive moisture and flammable vapuors or vapours
causing corrosion.
2. In the place of installation the temperature of ambient cannot exceed 60ºC and it should not be
lower than 0ºC. Moisture should range from 5% to 95% without condensation.
page 6
PL20130612
