14
Programming Piston Extended Position
For DUAL GATE Pull to Open:
17.
Remove sticker on end of the arm.
Press/release the SET button. P1 will
show
on the display.
Press Add to select
PC for push to close or PO for push to
open.
18.
Press/release the SET button
repeatedly
until display returns to dots.
19.
Press/hold the SET button until U1
is
on the display.
20.
The gate opener is in programming
mode. Press/hold DEC button. The sec-
ondary piston will slowly extend as you
hold DEC button.
Release the DEC button when the gate
reaches the closed position.
If DEC button is released it can be
pressed again to close further. If gate is
over closed press/hold ADD button to
retract piston.
Press/release SET button and U2 will
show on display. Repeat step 20 and
secondary piston will close
21. When closed position is correct
press/release the set button. Then press/
release ADD button.
The gates will slowly open to the full open
position. Once open it will automatically
close at full speed. Once closed, the
For DUAL GATE Push to Open:
17.
Remove sticker on end of the arm.
Press/release the SET button. P1 will show
on the display.
Press Add to select PC for
push to close or PO for push to open.
18.
Press/release the SET button repeatedly
until display returns to dots.
19.
Press/hold the SET button until U1 is
on the display.
20.
The gate opener is in programming
mode. Press/hold DEC button. The second-
ary piston will slowly extend as you hold
DEC button.
Release the DEC button when the gate
reaches the open position.
If DEC button is released it can be pressed
again to open further. If gate is past open
press/hold ADD button to retract piston.
Press/release SET button and U2 will show
on display. Repeat step 20 and secondary
piston will close
21. When open position is correct press/
release the set button. Then press/release
ADD button.
The gates will slowly close to the full open
position. Once closed it will automatically
open at full speed. Once open, the
programming is complete.
*Note: If reprogramming rather than programming for the first time read programming note in trouble shooting section first.
