13
Programming Piston Extended Position
For SINGLE GATE Pull to Open:
17. Remove sticker on end of the arm.
Press/release the SET button. P1 will show
on the display. Press/release DEC button
until 01 is on the display.
18. Press/release the SET button repeatedly
until display returns to dots.
19. Press/hold the SET button until U1 is
on the display.
20. The gate opener is in programming
mode. Press/hold DEC button. The piston
will slowly extend as you hold DEC
button.
Release the DEC button when the gate
reaches the closed position.
If DEC button is released it can be
pressed again to close further. If gate is
over closed press/hold ADD button to re-
tract piston.
21. When closed position is correct press/
release the set button. Then press/release
ADD button.
The gate will slowly open to the full open
position. Once open it will automatically
close at full speed. Once closed, the
programming is complete.
For SINGLE GATE Push to Open:
17. Remove sticker on end of the arm.
Press/release the SET button. P1 will show
on the display. Press/release DEC button
until 00 is on the display.
18. Press/release the SET button repeatedly
until display returns to dots.
19. Press/hold the SET button until U1 is
on the display.
20. The gate opener is in programming
mode. Press/hold DEC button. The piston
will slowly extend as you hold DEC
button.
Release the DEC button when the gate
reaches the open position.
If DEC button is released it can be
pressed again to open further. If gate is
past open press/hold ADD button to retract
piston.
21. When open position is correct press/
release the set button. Then press/release
ADD button.
The gate will slowly open to the full closed
position. Once closed it will automatically
open at full speed. Once open, the
programming is complete.
*Note: If reprogramming rather than programming for the first time read programming note in trouble shooting section first.
