ESP Safety IPES-IR/UV, Operating Manual

Page: 29 / 35

IPES-IR/UV Flame Detector
80010-001 R07 Operating Manual
Page 23 of 29
Revised 10/21/2013
13.0 Certifications
The IPES–IR/UV meets the following certifications:
FM (U.S. &
Canada)
Hazardous
Locations
Zone Locations
Class I, Zone 1, AEx d IIC, T5, Gb
1. ISO Class 12.9, M5 X 20 socket ‐ head cap screws (Yield Stress 1100 MPa) shall be
used to replace the cover fasteners.
2. ISO Class 12.9, M5 X 25 socket ‐ head cap screws (Yield Stress 1100 MPa) shall be
used to replace the base fasteners.
Fire Protection
Equipment
Approval Standards: FM3260 (2000); FM3600 (1998); FM3615 (2006); ANSI/ISA 60079 ‐ 0
(2009); ANSI/ISA 60079 ‐ 1 (2009); CAN/CSA ‐ C22.2 No. 60079 ‐ 0 (2007); CAN/CSA ‐ C22.2 No.
60079 ‐ 1 (2007)
Supporting Standards: ANSI/FM3260 (2004); ANSI/NFPA 72 (2002); ULC/ORD – C386 (1990);
CAN/ULC – S529 (2002); CSA C22.2 No. 0.5 (reaffirmed 1999); C22.2 No. 32 (reaffirmed 2003);
ANSI/IEC 60529 (2004); CSA ‐ C22.2 No. 60259 (2005)
ABS Class I, Division 1, Groups B, C & D,
T5 Ta = ‐ 40
o
C to +85
o
C ( ‐ 40
o
F to +185
o
F)
IP66
ATEX/
CE
Flameproof “d”
Ex d IIC T5 Gb Ta = ‐ 40
o
F to +185
o
F ( ‐ 40
o
C to +85
o
C)
Supporting Standards: EN 60079 ‐ 0:2009; EN 60079 ‐ 1:2007
ATEX Certificate Number: FM10ATEX0043X
Specific Conditions of Use:
1. ISO Class A2 ‐ 70, M5 X 16 socket ‐ head cap screws (Yield Stress 450 MPa) shall be
used to replace the cover fasteners.
2. ISO Class A2 ‐ 70, M5 X 16 socket ‐ head cap screws (Yield Stress 450 MPa) shall be
used to replace the base fasteners.
3. Consult the manufacturer if dimensional information on the flameproof joints is
necessary.
Certificate of Conformity: CE Mark for EMC (TUV)
CE Mark for ATEX
IP66