P
AGE
71
F
IRE
B
ALL
DVDM-100 I
NSTALLATION
& U
SER
’
S
G
UIDE
-
M22003-01A1
C
HAPTER
3 - G
ETTING
S
TARTED
Adding or Removing Changers
If a changer has been attached to FireBall DVDM-100, removed, and then re-attached,
FireBall DVDM-100 will assume that the disc collection has not changed. If you have
made disc changes, you should manually go to the
changer management
section in
SETUP and check all discs to insure that all discs are recognized.
If a changer has been attached to FireBall DVDM-100, but then is disconnected, the
discs still appear in the Guides, however they are not available for playback and are
indicated by a questin mark ‘?’ in the disc’s icon..
If supported changers are not found, you will be asked if you want to disconnnect the
changer permanantly, try again to locate it, or ignore the fact that it was not found.
WARNING!
Selecting “Disconnect” will permanently remove all discs in that changer from your
Music and Movies Guides. In order to re-connect the changer and show the discs in
the Guides, you must perform a full Autobuild on the changer if it is reconnected at a
later time.
