ERNITEC MicroView MVIB-04IR-E, User Manual

Page: 5 / 171

Network Camera User Manual
4
expose it to high electromagnetic radiation.

To avoid heat accumulation, ensure there is good ventilation to the device.

Keep the camera away from water and any liquids.

While shipping, pack the camera in its original, or equivalent, packing materials.
Or packing the same texture.

Improper use or replacement of the battery may result in hazard of explosion.
Please use the manufacturer recommended battery type.
Notes:
For the camera supports IR, you are required to pay attention to the following
precautions to prevent IR reflection:

Dust or grease on the dome cover will cause IR reflection. Please do not remove
the dome cover film until the installation is finished. If there is dust or grease on
the dome cover, clean the dome cover with clean soft cloth and isopropyl alcohol.

Make certain the installation location does not have reflective surfaces of objects
too close to the camera. The IR light from the camera may reflect back into the lens
causing reflection.

The foam ring around the lens must be seated flush against the inner surface of the
bubble to isolate the lens from the IR LEDS. Fasten the dome cover to camera body
so that the foam ring and the dome cover are attached seamlessly.