Network Camera User Manual
109
1.
Enter the Face Detection settings interface,
Configuration > Event > Smart
Event > Face Detection
.
2.
Check the
Enable Face Detection
checkbox to enable the function.
3.
Check the checkbox of
Enable Dynamic Analysis
for Face Detection, and then
the detected face is marked with green rectangle on the live video.
Note:
To mark the detected face on the live video, go to
Configuration > Local
to enable the
Rules
.
4.
Click-and-drag the slider to set the detection sensitivity. The Sensitivity ranges
from 1 to 5. The higher the value is, the more easily the face can be detected.
5.
Click
Arming Schedule
to set the arming schedule. Refer to
Task 2 Set the
Arming Schedule for Motion Detection
in
Section 10.1.1
for detailed steps
.
6.
Click
Linkage Method
to select the linkage methods for face detection. Refer to
Task 3: Set the Linkage Method Taken for Motion Detection
in
Section 10.1.1.
Face Detection
7.
Click
Save
to save the settings.
Summary of Contents for MicroView MVIB-04IR-E
