Keyboard 1500M/1501M Setup
If several parameters should be changed it is necessary to start from the beginning with each
parameter, by pressing the ESC and MENU keys at the same time, and entering the password.
The default password is 0000 (four times zero).
Default settings
The default settings are indicated with an '
*
' on the next page.
Each time a setting is changed, the keyboard is automatically re-booted in order to activate the
new setting. Invalid entries are not accepted, indicated by no key-beep.
Quick set-up
The basic settings of the keyboards 1500M/1501M can easily be set up, by pressing the
following keys during power ON of the keyboard:
ESC
+
0
: Direct Camera Control - RS485 - 2400 baud
ESC
+
2
: System Keyboard - RS232 - 19200 baud - Keyboard no. 2/3
ESC
+
3
: System Keyboard - RS485 - 19200 baud - Keyboard no. 3
ESC
+
4
: System Keyboard - RS485 - 19200 baud - Keyboard no. 4
ESC
+
5
: System Keyboard - RS485 - 19200 baud - Keyboard no. 5
ESC
+
6
: System Keyboard - RS485 - 19200 baud - Keyboard no. 6
The remaining settings are not affected by the above quick set-up procedure.
Change the keyboard type
Press the key
1
to change the keyboard type.
Press
1
to set the keyboard for
Direct Camera Contro
l, press
2
to set the
keyboard for
System Control
.
Change of keyboard address
Press the key
2
to change the
keyboard address
, press a number between
3
and
6
indicating the new
keyboard address
.
Change the baud rate
Press the key
3
to change the
baud rate
setting.
Press the key
1
for 1200 baud,
2
for 2400,
3
for 4800,
4
for 9600,
5
for 19200 or
6
for 38400
baud rate
.
Change the interface type
Press the key
4
to change the
interface
type.
Press
1
to set RS-232
interface
, press
2
to set RS-485
interface
.
Change the function of the AUX relays (refer to the AUX relays section on page 5)
Press the key
5
to change the function of the
AUX relays
.
Press
1
for latched function,
2
for un-latched,
3
for 1801M mode.
Calibrate joystick (1501M only)
This is a service function. Use this function to re-calibrate the joystick in case e.g. pan & tilts are
moving although the joystick is released.
Press the key
7
to activate the function
Release the joystick, including the focus!
Press the
CLR
key to calibrate the joystick.
Change the password
Installation and Setup instruction for Keyboard Series 1500
Page 6
