Erie water treatment pHneutralizer Series, Technical Manual

Page: 7 / 29

START-UP
Page 7
PRESSURIZING
1. Make sure the bypass system is in 'bypass' position.
2. Make sure the electronic controller of the water filter is
in service mode.
3. Open the mains water supply.
4. Open a cold treated water faucet nearby the water filter
and let the water run for a few minutes until all air is
purged and all foreign material that may have resulted
from the installation is washed out; close the tap.
5. Gently pressurize the water filter, by putting it into
service:

factory bypass:
1.
open the 'outlet' valve;
2. slowly open the 'inlet' valve.
 3-valve bypass:
1.
close the 'bypass' valve;
2. open the 'outlet' valve;
3. slowly open the 'inlet' valve.
6. After 2-3 minutes, open a cold treated water faucet
nearby the water filter and let the water run until all air is
purged from the installation and the filter media is
properly rinsed (it is normal for the rinse water to show
some discoloration!); let the water run until the rinse
water is clear; close the tap.
7. Check the water filter and all hydraulic connections for
leaks.

Calcium/magnesium will be added to the water when it
passes through the water filter, to raise its pH. As a
consequence the hardness of the treated water will be raised
also!
ELECTRONIC CONTROL PANEL
8.
Program the electronic controller.
PERFORM REGENERATION
9.
Manually initiate a regeneration, by pressing the scroll
button repeatedly until the display shows:
10. Leave the water filter in this position; the countdown
timer will countdown to 0 sec and start a regeneration.
Regen in 10 sec