52
Re-edit program
10
RE-EDIT PROGRAM?
“
Get screen-viewer
View
At this point you have finished editing the splicing program.
The splicer gives you a chance to go back, however, and
make adjustments you might have missed the first time
round.
If you are not sure about whether you are satisfied with the
current version of the program, you should press VIEW and
bring up the screen-viewer. The screen-viewer will give you a
list of all parameters (control and splicing) and their values.
If you are satisifed with the program, press No and end the
editing session. The splicer will tell you it is “Updating pa-
rameters...” and then return to splicing mode.
If you press Yes, you will return to step 5 (p. 46).
End editing session
No
“
UPDATING PARAMETERS...
“
“
ADVANCED OPERATION - Program editing
Once you have gone through the program editing se-
quence once or twice, you will probably no longer need
the step-by-step guide presented on these pages. Never-
theless, you may still want some reference for locating
specific parameters and keeping tabs on where you are in
the overall editing tree. If this is the case, you can look at
the program editing flow chart in Appendix C, p. 77 .
Change security code?
Y
N
New code xx.x