E
Em
me
errg
ge
en
nc
cy
y O
Op
pe
erra
at
tiio
on
n
The radio’s ability to declare an emergency, clear an emer
-
gency, remain locked on an emergency system and group, and
the emergency audio and display freeze can each be enabled or
disabled through programming. When an emergency is declared
scanning will stop and restarts only after the emergency has
been cleared.
R
Re
ec
ce
eiivviin
ng
g A
An
n E
Em
me
errg
ge
en
nc
cy
y C
Ca
allll
When receiving an emergency call from the selected group
and system, an alert beep is heard and
comes on. The message
**R
RX
XE
EM
ME
ER
R**
flashes in the display on line
two until the emergency condition is cleared. Follow standard
emergency procedures.
D
De
ec
clla
arriin
ng
g A
An
n E
Em
me
errg
ge
en
nc
cy
y C
Ca
allll
To send an emergency call to the selected system and group
(or on an optionally preprogrammed group), proceed as follows:
1.
Press and hold the red EMERGENCY button that is on top
of the radio in front of the antenna for approximately one
second (this time is programmable and therefore could be
longer or shorter; check with the system administrator).
The radio will transmit an emergency call request with the
radio ID until an emergency channel assignment is received.
2.
When the working channel assignment is received, the radio
sounds a single beep (Autokey alert tone) indicating it is
ready for voice transmission.
**T
TX
XE
EM
ME
ER
R**
flashes on line two in the display until the emer
-
gency is cleared.
B
BS
SY
Y
B
BS
SY
Y
W
WH
HC
C
X
XM
MIIT
T
3
36
6
