8
Uncoil the Input Cord (connected to
control box’s Power port) and plug it into
Power Supply.
Insert the Power Cord into the Power
Supply.
Carefully flip the base over on to its legs. Important: Two people are
required to move the bed base. Do not drag across the floor. Do not rest
frame on its side, excessive pressure may damage the legs.
5
6
7
Legs are shipped fully assembled. Alternative heights in 3" increments
can be achieved by removing leg segments.
To install the legs, thread the washer over the bolt of the leg with the
recessed side facing the leg, and tighten by hand. Do not over tighten.
3
Step 5:
Connect The Wand to the
Control Box Cable via the 3-pin
connector.
Step 6:
Snap the hose into the slot.
Summary of Contents for quest 1.0
Page 33: ...17 notes...
Page 57: ...21 notes...
