ergoline ergoselect 400, Operator'S Manual

Page: 51 / 56

- 51 -
G
uIdanCe and
m
anufaCturer
’
s
d
eClaratIon
– e
leCtromaGnetIC
I
mmunIty
The ergoselect ergometer is intended for use in the electromagnetic environment specified below. It is the responsibility
of the customer or user to ensure that the ergoselect ergometer is used in such an environment.
Immunity Test IEC 60601 Test Level Compliance Level Electromagnetic Environment - Guidance
Electrostatic discharge (ESD)
to EN 61000‑4‑2 ± 6 kV contact
± 8 kV air ± 6 kV
± 8 kV Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the relative
humidity should be at least 30%.
Electrical fast transient/burst
to EN 61000‑4‑4 ± 2 kV for power supply lines
± 1 kV for input and output lines ± 2 kV passed Mains power should be that of a typical commercial
or hospital environment.
Surge to EN 61000‑4‑5 ± 1 kV differential mode
± 2 kV common mode ± 1 kV
N/A Mains power should be that of a typical commercial
or hospital environment.
Voltage dips, short interrup‑
tions and voltage variations
on power supply input lines
to EN 61000‑4‑11 < 5 % UT
(> 95 % dip in UT)
for 0.5 cycles
40 % UT
(60 % dip in UT)
for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles
< 5 % UT
(> 95 % dip in UT) for 5 s
< 5 % UT
40 % UT
70 % UT
< 5 % UT
Mains power should be that of a typical commercial
or hospital environment. If the user of the ergoselect
ergometer requires continued operation during power
mains interruptions, it is recommended that the
ergoselect ergometer be powered from an uninter‑
ruptible power supply or a battery.
Power frequency (50/60 Hz)
magnetic field to EN 61000‑4‑8 3 A/m passed Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical
commercial or hospital environment. The ergoselect
ergometer has no components susceptible to mag‑
netic fields.
NOTE: UT is the a.c. mains voltage prior to application of the test level.