ergoline ergoselect 400, Operator'S Manual

Page: 12 / 56

- 12 -
1
2
m
ountInG the
w
heelChaIr
a
CCess
r
amP
• Slide the support tubing of the wheelchair ramp onto
the guide tube on the ergoselect arm ergometer (1)
and tighten the clamping lever (2).
• Tighten the two nuts between support tubing and
ramp (3) by hand.
Before doing so, check that the ramp is flat on the
floor!
• Open the clamping lever again and pull the support
tubing of the ramp (4) off the guide tube (5).
• Tighten the two nuts on the underside of the ramp
with a fork wrench (SW 17) (6).
• You can now slide the support tubing of the ramp
onto the guide tube again and the ramp is ready for
use.
a
PPlICatIon
• Lift the wheelchair at the front and carefully place it
on the ramp.
• If the maneuvering range is not sufficient, the ramp
can be reversed 180° before being slipped onto the
guide tube.
M
ounting the wheelchair access raMp
f
astening the access raMp
Caution
• Equipment Damage •
When adjusting or mounting the access ramp, be sure not to lift
the base plate.
Choose an adjustment where the guide tube will never be bent
upward or downward when the access ramp is repositioned.