ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
6. Mounting the mitre saw
WARning!
To avoid injury from unexpected
saw movement:
• Disconnect the power cord from the socket,
and lock the cutting head in the lower position
using the stop latch.
• Lock the slide carriage in place by tightening
the slide carriage lock knob.
• To avoid back injury, lift the saw by using the
designated carrying handles located on the
top of the machine. When lifting, bend at your
knees, not from your back.
• Never carry the mitre saw by the power cord
or by the switch handle. Carrying the tool by
the power cord could cause damage to the
insulation or the wire connections resulting in
electric shock or fire.
• To avoid injury from flying debris, do not allow
visitors to stand near the saw during any cutting
operation.
• Support the saw on a level work surface.
• Bolt or clamp the saw to its support.
Mounting instructions
1) For stationary use, place the saw in the desired
location, directly on a workbench where there
is room for handling and proper support of the
workpiece. The base of the saw has four mounting
holes. Bolt the base of the mitre saw (1) to the
work surface (5),using the fastening method as
shown in Fig 9.
2) For portable use, place the saw on a
20mm(approx) thick piece of plywood. Bolt the
base of the mitre saw securely to the plywood
using the mounting holes on the base. Use
G-clamps to clamp this mounting board to a stable
work surface at the worksite. (See fig. 10)
note:
Mounting hardware is not included with this
tool. Bolts, nuts, washers and screws must be
purchased separately.
Fig 9
Fig 10
1) Hex headed bolt
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
1
2
3
4
5
6
7
8
9
