ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
• With the power switch OFF, bring the saw
blade down to the workpiece to see the cutting
path of the blade
• Squeeze trigger switch to start saw.
• Lower blade into workpiece with a firm
downward motion.
Finishing a cut:
• Hold the cutting arm in the down position.
• Release trigger switch and wait for all moving
parts to stop before moving your hands and
raising the cutting arm.
Before releasing jammed material:
• Release trigger switch.
• Wait for all moving parts to stop.
• Unplug the mitre saw.
4. Basic saw operations
WARning!
For your convenience, your
saw has a blade brake. The brake is
not a safety device. Never rely on it to replace
the proper use of the guard on your saw. If
the blade doesn’t stop within approximately 8
seconds, wait for the blade to stop, unplug the
saw and contact customer service.
To turn saw on
Push down the lock lever (1) and squeeze the
trigger switch (2) to turn the mitre saw ON.
Release the trigger switch to turn the saw OFF.
(See fig. 28)
5. Sliding carriage system
1) For chop cutting operations on small
workpieces, slide the cutting head assembly
completely toward the rear of the unit and
tighten the carriage lock knob (1).
2) To cut wide boards up to 300mm, the
carriage lock knob must be loosened to allow
the cutting head to slide freely. (See fig. 29)
Before leaving the saw
• Never leave tool running unattended. Turn
power OFF. Wait for all moving parts to stop.
• Make workshop childproof. Lock the shop.
Disconnect master switches. Store tool away
from children and other unqualified users.
Fig 28
Fig 29
1
1
2
