ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
8. Compound cut
A compound cut is the combination of a mitre
and a bevel cut simultaneously.
1) Loosen the bevel lock handle (1) and position
the cutting head at the desired bevel position.
Lock the bevel lock handle.
2) Loosen the mitre handle (2). Press down the
positive stop locking lever (3) and position the
table at the desired angle. Release the positive
stop locking lever and lock the mitre handle.
(See fig. 32)
iMPORTAnT
When cutting a maximum RH or LH compound
cut (mitre at 45˚ bevel at 45˚) move the RH
or LH fence extension by first loosening the
locking screw (A) and secondly pulling the
locking pin (B) and sliding the extension away
from the cutting area (C). (See fig. 32)
9. Slide cutting wide boards up to 300mm wide
WARning!
To avoid injury:
• Never pull the cutting head assembly and
spinning blade toward you during the cut. The
blade may try to climb up on the top of the
workpiece, causing the cutting assembly and
spinning blade to kick back, forcefully. The
cutting head assembly should be drawn back
completely then pushed forward when sawing.
• Let the blade reach full speed before cutting.
This will help reduce the risk of a thrown
workpiece.
Fig 32
1
2
3
B
A
C
