ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
ADJUSTMENT INSTRUCTIONS
1. Bevel stop adjustment
WARning!
To avoid injury from an
accidental start, make sure the switch is
in the OFF position and the plug is not connected
to the power source socket.
2. 90° (0°) Bevel adjustment
1) Loosen bevel lock handle (1) and rotate the
cutting arm completely to the right until it stops
against the vertical stop. Tighten the bevel lock
handle.
2) Place a combination square (2) on the mitre
table with the ruler against the table and the
heel of the square against the saw blade.
3) If the blade is not 90
°
(0
°
) square with the mitre
table (5), loosen the bevel lock handle (1), tilt the
cutting head to the left, loosen the locknut (4) on the
bevel angle adjustment bolt (3) and use an allen key
to adjust the socket headed stop bolt (3) depth in or
out to increase or decrease the bevel angle.
4) Tilt the cutting arm to back to the right at 90
°
(0
°
) bevel and recheck for alignment.
5) Repeat steps 1 through 4 if further adjustment
is needed.
6) Tighten bevel lock handle (1) and locknut (4)
when alignment is achieved. (See fig. 19)
Fig 19
5
2
4
3
1
