ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
6. Bevel adjustment 33.9
o
If necessary the 33.9
°
settings can be checked
and adjusted. A vernier angle gauge will be
required and this must be accurately set to
33.9
°
1) Set the cutting head to 33.9° by deploying
the crown moulding pin. Check the angle of
the blade against the machine table using the
vernier angle gauge. (See fig. 23)
2) If adjustment is required loosen the locknut
(3) to the relevant socket headed stop screw.
Adjust the screw in or out until the correct bevel
angle is achieved. Retighten the locknut. (See
fig. 22)
7. Mitre angle adjustment
The sliding compound mitre saw scale can be
easily read, showing mitre angles from 0° to
45° to the left, and 0° to 45° to the right. The
mitre saw table has nine of the most common
angle settings with positive stops at 0°, 15°,
22.5°, 31.6°, and 45°. These positive stops
position the blade at the desired angle quickly
and accurately. Follow the process below for
quickest and most accurate adjustments.
1) Unlock the mitre table by turning the mitre
handle (1) counterclockwise.
2) Move the turntable while lifting up on
the positive stop locking lever (2) to align
the indicator (3) to the desired degree
measurement.
3) If the desired angle is one of the nine positive
stops, release the positive stop locking lever,
making sure the lever snaps into position, and
then secure by tightening the mitre handle.
4) If the mitre angle desired is not one of the
nine positive stops, simply lock the mitre table
into position by turning the mitre handle in the
clockwise direction. (See fig. 24)
8. Mitre scale indicator adjustment
1) Move the table to the 0° positive stop.
2) Loosen the screw (4) that holds the indicator
with a Phillips screwdriver.
3) Adjust the indicator (3) to the 0° mark and
retighten screw. (See fig. 24)
Fig 24
Fig 23
1
2
4
3
