ERBAUER 254MM (10”) SinglE BEVEl SliDing MiTRE SAW
WARning!
Do not use solvents on the
guard. They could make the plastic
“cloudy” and brittle.
WARning!
When cleaning the lower
guard, unplug the saw from the power
source to avoid unexpected startup.
Sawdust
Periodically, sawdust will accumulate under the work
table and base. This could cause difficulty in the
movement of the worktable when setting up a mitre
cut. Frequently blow out or vacuum up the sawdust.
WARning!
If blowing sawdust, wear
proper eye protection to keep debris
from blowing into eyes.
lubrication
All the motor bearings in this tool are lubricated
with a sufficient amount of high grade lubricant
for the life of the unit under normal operating
conditions; therefore, no further bearing
lubrication is required. Lubricate the following as
necessary: Chop pivot: Apply light machine oil.
Central pivot of plastic guard: Use light household
oil (sewing machine oil ) on metal-to-metal or
metal-to-plastic guard contact areas as required
for smooth, quiet operation. Avoid excessive oil,
to which sawdust will cling. Guard arm: (which
actuates the lower guard movement) may be oiled
at the rear pivot, greased at ball bearing contact,
and oiled where the guard arm actuates the
acetyl roller of the lower guard, if the down chop
motion is hard.
