W
13
ERBAUER 216MM (8”) SLIDING MITRE SAW
5. Installing the dust bag
1) Squeeze the metal collar wings (2) of the dust
bag (1).
2) Place the dust bag neck opening around the
exhaust port (3), and release the metal collar wings
(See fi g. 6).
6. Installing the hold-down clamp
1) Loosen the lock knob (1) from the rear side of
the saw base (2) (See fi g. 7).
2) Place the hold-down clamp assembly (3) in one
of the mounting holes (4) (See fi g. 8).
3) Tighten the lock knob (1) (See fi g. 7).
Warning:
When using stop block on the
right side, hold-down clamp must also be
in right side. Using hold-down clamp on the left
side during this operation can cause kickback and
serious injury to the operator.
7. Removing and installing the table insert
Warning:
To avoid injury:
●
Always unplug the saw to avoid accidental
starting. Remove all small pieces of material from
the table cavity before performing any cuts. The
table insert may be removed for this purpose, but
always reattach the table insert prior to performing
a cutting operation.
●
Do not start the sliding compound mitre saw
without checking for interference between the
blade and table insert. Damage could result to
the blade, table insert or turntable if blade strike
occurs during the cutting operation.
1) To remove, loosen and remove the six
screws (1) on the table insert (2) with a Phillips
screwdriver and remove the insert.
2) To install, reposition the table insert, install the
six screws and tighten.
3) Check for blade clearance by moving the slide
carriage through the full motion of the blade in the
table slot (See fi g. 9).
Note:
Replacement table inserts available from
01709 876611.
Fig 6
Fig 7
Fig 8
Fig 9
2
1
3
1
2
3
1
2
4
4
