W
25
ERBAUER 216MM (8”) SLIDING MITRE SAW
10. Cutting bowed material
A bowed workpiece must be positioned
against the fence and secured with a clamping
devise before cutting as shown. Do not
position workpiece incorrectly or try to cut the
workpiece without the support of the fence.
This will cause the blade to bind and could
result in personal injury (See fi g. 36).
11. Workpiece support and repetitive
cutting using the stop plate
Long pieces need extension table support.
1) Loosen the knob (1) then slide the
extension table to desired position and tighten
the knob.
2) The stop plate is designed for use during
repetitive cutting. Only use one stop plate at
a time. Loosen the locking bolt (2), rotate the
stop plate (3) to vertical position and retighten
the locking bolt (See fi g. 37).
12. Auxiliary wood fence
When making multiple or repetitive cuts that
result in cut-off pieces of one 25.4 mm or
less, it is possible for the saw blade to catch
the cut-off piece and throw it out of the saw
or into the blade guard and housing, possibly
causing damage or injury. To minimize this, an
auxiliary wood fence can be mounted to your
saw (See fi g. 38).
Holes are provided in the saw fence to attach
an auxiliary wood fence. This fence is to be
constructed of straight wood approximately
19.05 mm thick by 63.5 mm high by 457.2 mm
long.
Attach the wood fence securely and make a
full depth cut to make a blade slot.
1
2
3
Fig 36
Fig 37
Fig 38
blade slot
