W
17
ERBAUER 216MM (8”) SLIDING MITRE SAW
Laser Warning Label: Max output <1mW
Wavelength: 630-670nm EN 60825-1/
A1:2002. Laser radiation do not stare into
beam Class 2 Laser Product Puissance.
Note:
All the adjustments for the operation
of this machine have been completed at the
factory. Due to normal wear and use, some
occasional readjustments may be necessary.
A. Check Laser Beam Alignment.
1) Mark a 90° straight line across a board
to serve as a “pattern line” to test laser
alignment. Lay the board on the mitre table.
2) Plug saw into outlet and turn on the laser
beam and line it up with the pattern line.
3) Lower saw blade to pattern line and if blade
is not fl ush with the pattern line, adjust as
follows in procedure (B).
B. Adjusting the Angle of the Laser Guide
1) Turn the laser element (3) in the desired
direction to adjust the laser angle.
Note:
Do not adjust the laser more than1/4
turn in either direction as this may damage
the laser. There are two fl at sides on the laser
element where you can position an adjustable
spanner for your adjustment. (See fi g. 20, 21).
C. Aligning The Laser Beam
1) Loosen only 1/2 turn at a time the four set
screws (5) (See fi g. 20, 21).
2) Adjust laser by turning the left side set
screw clockwise to shift the laser line to the
right. To shift the laser line to the left, turn the
right side set screws 1/2 turn at a time.
3) Once alignment of the laser is achieved,
tighten only 1/2 turn at a time the four set
screws (5) (See fi g. 22).
Left Side View
Right Side View
Fig 20
Fig 21
Fig 22
5
3
3
3
5
