12
ERBAUER 216MM (8”) SLIDING MITRE SAW
ASSEMBLY
SSEMBLY INSTRUCTIONS
INSTRUCTIONS
Warning:
To avoid injury, do not connect this
mitre saw to the power source until it
is completely assembled and adjusted and you
have read and understood this Operator’s Manual.
1. Installing the mitre handle
1) Thread the mitre handle (1) into the hole located
at the front of the mitre table (See Fig. 3).
2. Unlocking the slide carriage
After removing the saw from the carton, loosen
the slide carriage lock knob (1). When transporting
or storing the mitre saw, the slide carriage should
always be locked in position. The slide carriage
lock knob (1) is located on the bottom of the slide
carriage (See Fig. 4).
3. Saw blade spanner
1) For convenient storage and prevention of loss,
there is a slot (1) located at the rear of cutting
handle for storing the blade spanner (2) (See Fig.
5).
4. Cutting head
Raising
1) Push down slightly on the switch handle (4) and
the lock lever (5).
2) Pull out the stop latch knob (3).
3) Allow the cutting head to rise to the up position
(See Fig. 5).
Warning:
To avoid injury and damage
to the saw, transport and store the mitre saw
with the cutting head locked in the down position.
Never use the stop latch to hold the cutting head in
a down position for cutting operations.
Locking
When transporting or storing the mitre saw, the
cutting head should always be locked in the down
position.
1) Push the lock lever (5) and cutting head down to
its lowest position.
2) Push the stop latch knob (3) into the locking hole.
IMPORTANT
To avoid damage, never carry the mitre saw by the
switch handle, the cutting arm or the mitre handle.
ALWAYS use the designated carrying handle.
Fig 3
Fig 4
Fig 5
1
1
1 2
3
4
5
