18
ERBAUER 216MM (8”) SLIDING MITRE SAW
ADJUSTMENT
ADJUSTMENT INSTRUCTIONS
INSTRUCTIONS
1. Bevel stop adjustment
Warning:
To avoid injury from an
accidental start, make sure the switch is in
the OFF position and the plug is not connected to
the power source outlet.
2. 90° (0°) Bevel adjustment
1) Loosen bevel lock handle (1) and tilt the
cutting arm completely to the right. Tighten the
bevel lock handle.
2) Place a combination square (2) on the mitre
table with the ruler against the table and the
heel of the square against the saw blade.
3) If the blade is not 90
o
(0
o
) square with the
mitre table (5), loosen the bevel lock handle (1),
tilt the cutting head to the left, loosen the locknut
(4) on the bevel angle adjustment bolt (3) and
use a 10 mm spanner to adjust the stop bolt (3)
depth in or out to increase or decrease the bevel
angle.
4) Tilt the cutting arm to back to the right at 90
o
(0
o
) bevel and recheck for alignment.
5) Repeat steps 1 through 4 if further adjustment
is needed.
6) Tighten bevel lock handle (1) and locknut (4)
when alignment is achieved (See fi g. 23).
Fig 23
1
2
3
4
5
