D
Use the
d
/
u
buttons to select a media setting
bank number between 1 and 30 and then press
the
Z
button.
Note that any settings already saved in the printer
will be overwritten.
E
Use the
d
/
u
buttons to select
Head Alignment
and press the
Z
button.
F
Use the
d
/
u
buttons to select
Manual(Uni-D)
or
Manual(Bi-D)
and press the
Z
button.
G
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
Cut the media if necessary.
U
Note:
To rewind the media, press
u
. Stop rewinding
before the media is past the cutter groove (on the
pressure roller side).
If the leading edge of the media is curled, stop
rewinding before the media reaches the inner side
of the front cover.
H
Check the pattern and select the pattern number
that has the least gaps.
In the following example, this would be pattern
number 2.
1
C1
2
3
I
When
C1
is displayed in the control panel, use
the
d
/
u
buttons to select the number recorded in
Step 8 and press the
Z
button.
J
Select the numbers for all colors and press
Z
.
K
The media setup menu will be displayed when
you enter the pattern number for the last color.
Feed Adjustment
Feed Adjustment
is used to correct banding (horizontal
banding, lines, or strips of uneven color).
Two methods are available for Feed Adjustment:
❏
Visually inspect print results and enter a correction
by hand.
❏
Enter a correction during printing and inspect the
results.
Note:
Feed Adjustment
varies with the media used. Load the
media for which feed adjustment is required under the
same conditions as the actual print job. For example, if
you are using the auto take-up reel unit for printing, the
auto take-up reel unit should also be used for feed
adjustment.
Furthermore, when installing the heavy roll media
system, the media must be loaded and feed adjustment
performed again, even if once you adjust with the
standard roll media system.
SC-F7000 Series User’s Guide
Basic Operations
46
