Epson Stylus C87, Service Manual

Page: 68 / 109

EPSON Stylus C87/C88/D88 Revision A
DISASSEMBLY/ASSEMBLY Dissasembly Procedures 68
4.3.3.7 Front Frame
1) Remove the Housing, Upper Assy. (p47)
2) Move the CR Unit to the center of the printer. (See 4.3.3.2 Removing Holder
Shaft Unit Step 2)
3) Remove both the two screws that secure the Front Frame to the Main Unit and
the Front Frame Stopper.
• C.B.S. 3 x 6: 2
4) Lift up the CR Unit, and remove the Front Frame.
Figure 4-59. Removing Front Frame
CR Unit
Front Frame
1
C.B.S. 3 x 6
( 8
±
1 kgf.cm )
Positioning
Hole and RIb
Front Frame
Stopper
2
C.B.S. 3 x 6
( 8
±
1 kgf.cm )
Positioning
Hole and RIb
Front Frame
Stopper
„ Match the positioning hole with the rib as shown in Figure 4-59
when installing the Front Frame.
„ Secure the screws in the order shown in Figure 4-59 .
A D J U S T M E N T
R E Q U I R E D
„ When Front frame is removed or replaced with new one, the
following adjustment must be performed in the order below.
1. First Dot Adjustment
2. Head Angular Adjustment
3. Bi-D Adjustment
„ When you replace Front frame with new one, lubricate it as
specified. See
Chapter 6 “Lubrication” (p.95) for details.