Epson S5U1C63000A, User Manual

Page: 253 / 346

CHAPTER 8: DEBUGGER
S5U1C63000A MANUAL
EPSON
239
(S1C63 FAMILY ASSEMBLER PACKAGE)
Error message Content of message (Commands involved)
Incorrect register name, The specified register name is invalid. (rs)
use PC/A/B/X/Y/F/SP1/SP2/EXT/Q
Input address does not exist
Attempt is made to clear a break address that has not been set. (bp)
invalid command This is an invalid command. (All commands)
invalid data pattern The input data pattern is invalid. (bd, br)
invalid file name The file name (extension) is invalid. (lo)
invalid value The input data, address or symbol is invalid. (All commands)
Maximum nesting level(5) is exceeded, Nesting of the com/cmw command exceeds the limit. (com, cmw)
cannot open file
MLA address out of range, use 0–0xFFF
MLA address is invalid. (od)
no such symbol There is no such symbol. (All symbol support commands)
no symbol information No symbol information is available since the ".ABS" file has not
been loaded. (sy)
Number of passes out of range, use 0–4095 The specified pass count for sequential break is out of range. (bs)
Number of steps out of range, use 0–65535 The specified step count is out of range. (s, n)
SO address out of range, use 0–0x1FFF SO address is invalid. (od)
SP1 address out of range, use 0–0x3FF The specified SP1 address is out of range. (bsp)
SP2 address out of range, use 0–0xFF The specified SP2 address is out of range. (bsp)
symbol type error The specified symbol type (program/data) is incorrect.
(All symbol support commands)
Warning message Content of message (Commands involved)
Break address already exists Attempt is made to set an already-set break address. (bp)
Identical break address input Input command contains identical address.
round down to multiple of 4 Watch data address is invalid. (dw)
User cancel Command is aborted by the user. (xfer/xfers, xfwr/xfwrs, xfcp/xfcps)
Verify error FPGA verify error. (xfcp/xfcps)