Epson EMP 6110, User Manual

Page: 54 / 84

Problem Solving
54
f
Problems when projection starts
f
Power does not turn on
f
The fan noise is abnormally loud
f
Other problems
f
No sound can be heard or the sound is faint
Check Remedy
Did you press the [Power] button? Press the [Power] button to turn the power on.
Are the indicators switched off? The power cable is not connected correctly or power is not being supplied normally.
Connect the projector's power cable correctly.
s
Quick Start Guide
Check that your electrical outlet or power source is functioning correctly
Do the indicators turn on and off when the power cable is
touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service
Guide .
s
Epson Projector Contact List
Is the operation lock set to "Full Lock"? Press and hold down the [Enter] button on the control panel for about seven seconds, a message is displayed
and the lock is released.
s
p.27
Is the correct setting for the remote receiver selected? Check "Remote Receiver" from the configuration menu.
s
"Settings"-"Remote Receiver" p.33
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off? When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn
back on. Press the [Power] button to turn the power back on.
Check Remedy
Is the fan loud only when the power is first turned on? When the power is first turned on, the projector performs an air filter efficiency check. This check involves
running the fan at a higher than normal speed producing the louder noise. This is normal.
Check Remedy
Is the audio source connected correctly? Check that the cable is connected to the Audio port.
Is the volume adjusted to the minimum setting? Adjust the volume so that sound can be heard.
s
Quick Start Guide
Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s
p.16
Is the audio source setting correct? Check the "RCA Audio Input" setting on the configuration menu.
s
p.33
Only when video equipment is connected to
the EMP-6110