Epson EMP 6110, User Manual

Page: 45 / 84

Problem Solving
45
f t
Power indicator lights red
: Lit : Flashing: : Off
Status Cause Remedy or Status
Internal Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the
nearest address provided in the
Support and Service Guide .
s
Epson Projector Contact List
Fan Error
Sensor Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the
nearest address provided in the
Support and Service Guide .
s
Epson Projector Contact List
High Temp Error
(overheating) The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the
projector switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s
p.58 , 65
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service Guide .
s
Epson Projector Contact List
When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On".
s
p.35
Note that when the projector is used at altitudes in excess of 1500 m with the smoke filter attached, an internal High
Temp error may occur repeatedly depending on the ambient temperature. Should this occur, set the "Brightness
Control" to "Low".
s
p.33
If the High Temp errors continue to occur, replace the smoke filter with a new one.
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service Guide .
s
Epson Projector Contact List
Abnormal
Red Red Red
Red Red
Red Red