Status
Cause
Remedy or Status
When using at an altitude of 1500 m or more, set
High Altitude Mode
to
On
.
s
Lamp Error
Lamp Failure
Check the following two points.
•
Take out the lamp and check if it is cracked.
s
•
Clean the air filter.
s
If the lamp is not cracked
: Reinstall the lamp and turn on the power.
If the error continues
: Replace the lamp with a new one and then turn on the power.
If the error continues
: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s
If the lamp is cracked
: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be
projected until the lamp is replaced.)
s
When using at an altitude of 1500 m or more, set
High Altitude Mode
to
On
.
s
Auto Iris Error
Power Err. (Ballast)
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s
Filter Airflow Error
Check the following two points.
•
Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
•
If the air filter is clogged, clean or replace it.
s
s
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s
Problem Solving
97
Summary of Contents for EB-4550
