Epson ActionPC 6000, User Manual, Page: 73 / 144

Follow these steps to install video memory chips:
1.
2.
3.
4.
5.
6.
7.
Locate the video memory chip sockets on the left side of the
main system board, shown on page 4-5. The chip sockets
are labelled U53 and U57.
If there is an option card in your way, remove it. See
page 4-18 for instructions.
Caution
To avoid generating static electricity and damaging the
memory chips, ground yourself by touching the metal
surface on the inside of the computer’s back panel. Then
remain as stationary as possible while you install them.
Position the chip over the socket and align the notch in the
chip’s corner with the notch in the corner of the socket.
Gently press the chip into the socket; then push down firmly
on both ends to make sure it is well-seated.
Repeat steps 3 and 4 to install the other chip.
Replace any option cards you removed; see page 4-15.
Now run SETUP as described in Chapter 2 so that your
system recognizes the increased video memory.
Installing and Removing Options 4-19