Epson 1735W - PowerLite WXGA LCD Projector, User Manual

Page: 38 / 159

38
Using the Remote Control
2. Press the
ID
button on the remote control. You see a message on
the screen, showing the projector’s ID:
If the message says the remote control is “On,” then you can use
the remote control to operate that projector. If it says “Off,” then
you have to change the ID of the remote control before operation
is possible, as described in the next section.
Setting the Remote Control ID
The remote control’s default ID is zero. This lets it operate any
projector. To set it to operate only those projectors with a specific ID,
follow these steps:
1. Press and hold the
ID
button on the remote control.
2. While holding the
ID
button, press the numbered button on the
remote control (1 through 9) that corresponds to the ID of the
projector(s) you want to operate. Selecting zero lets you control all
projectors.
note
If you’re using a remote
control ID other than the
default ID of zero, you have
to set the ID each time you
turn on the projector.