Epever EG1200CU, User Manual

Page: 12 / 32

way, the device in the constant-current mode will be converted to the
constant-voltage mode automatically when the load voltage reaches at the
output voltage setpoint.
The output voltage or current value can be set directly on real-time
interface in power mode.
Section II Charging Mode Introduction
The charging voltage has two points in battery charging mode, one is
equalize voltage and the other is float voltage. The equalizing charging
mode has two parameters of Equalize Duration and Equalize Calendar. The
equalize voltage, float voltage, Equalize Duration (duration after the stable
of equalize charging point) and Equalize Calendar (period between the two
equalize charging mode) all can be set. At the same time it can realizes the
limitary-current charging by setting the output current.
After each time of turning on the power, the device will be converted to
automatic float charging mode, the Equalize Calendar will be start (the
Equalize Calendar starts for the next cycle only after finishing the last
Equalize Duration except for the first time of turn on the power). At this
point, whether there is output or not, the device will be converted to the
automatic float charging mode and the green LED will be lighted on solid
when the Equalize Calendar is finished. When the device detects that the
output voltage excess the value that is lower 0.5V than the equalize
setpoint, the Equalize Duration will be start and will not be stopped until
-8-