EP Equipment LIST JX0, Service Manual

Page: 200 / 206

187
REV. 07/2019
SERVICE MANUAL - BATTERY
B
B3 Lithium Battery(operational)
B3-1 Safety and Warnings
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
DO NOT short-circuit battery.
DO NOT collide, handle gently, and avoid
DO NOT place the battery or battery pack in
a corrosive chemical environment.
DO NOT charge the battery without a
charging device or with a charging device
that we do not recognize.
DO NOT expose the battery or leave it in an
environment above 45 °C for a long time.
DO NOT disassemble, squeeze, puncture or
heat the battery.
Lithium batteries are forbiddento be used by
those who lack the knowledge of safe use of
lithium batteries.
DO NOT immerse the battery in water or
other conductive liquids.
DO NOT use the battery in series or in
parallel with other models or types of
batteries.
Serial and parallel operation of a complete
power supply system containing a lithium-
ion battery protection circuit board or battery
management system is prohibited.
It is strictly forbidden to hot swap battery to
avoid fire or electric shock.
Be careful of corrosion to avoid damage to
the battery or shortening its life.
Smoking, spark or open flames are strictly
prohibited near the battery.
Before the first use, charge battery comletely
with original charger.
The lithium battery should be used at an
ambient temperature of -20°C ~ 45°C, do not
use or store the battery near a fire source/
heat source where the temperature exceeds
the safety range;
When the battery is low, please charge the
battery in time to avoid over-discharge; the
replaced battery should also be charged
in time to avoid damage caused by over-
discharge of the battery after self-discharge.
Do not place metal objects (such as
wrenches, knives) on the lithium battery, or
other objects that may cause short-circuiting
of the battery to avoid short circuit between
the positive and negative terminals;
As for failure to comply with instructions for use,
maintenance without using origi-nal parts or user
corruption of provisions when adding electrolyte
and other circumstances, the quality assurance will
automatically void.
Do not bump or strike the lithium battery
during use, If leakage is found on the battery,
stop using it right away, pull out all the plugs
connected to it, place it in open and well-
ventilated space, and contact the after-sales
service.
If the battery life is significantly shortened,
please contact the after-sales for check;
If the lithium battery fails and cannot be used,
please remove the battery from the material
handling equipment, the trained personnel can
use our BMS special reading instrument to
read the information for preliminary judgment;
for problems that cannot be solved, please
contact the after-sales service department for
solutions;
Before installing and removing the battery, be
sure to read the user manual; the weight of the
battery body is evenly distributed, please pay
attention to the installation
.
-
-
-
-