EP Equipment LIST JX0, Service Manual

Page: 20 / 206

7
REV. 07/2019
INFORMATION & SPECIFICATIONS
1
This series are electric task support vehicle. Its
important structure is as shown in Figure 50001.
- Please refer to the nameplate for rated load
capacity of the vehicle.
-
The vehicle can only be used on the level gro-
und indoors, never use it on mezzanine or
balcony area.
WARNING
The truck is driven forward or backward by DC
motor. The lifting and lowering of mast can also
drive the truck, while the travel speed will be
limited.
The Electric Power Steering has greatly met the
demand for high mobility of the truck.
Truck can only be operated by single operator;
other personnel is forbidden from riding.
1.3 Common Tools
No. Name Remark
1 Hex Wrench 2#~14# One Set
2 Hex Head Socket Wrench 8#~24# One Set
3 Phillips Screwdriver 2# One Piece
4 Slotted Screwdriver 2# One Piece
5 Sockets and Knobs One Set
6 Circlip Pliers One for holes and one for shaft
7 Hammer One Piece
8 Spreader, Crane One Pair
9 Cylinder Wrenches For removal and installation of cylinders
10 Diagonal Pliers One Piece
11 Cylinder Pliers One Piece
12 Grease Gun One Piece
13 Tiger Tooth Wrench 22#/27# One of Each
WARNING
When the platform is lifted, the door will not
open. In the raised position, a pressure-
sensitive switch monitors the area between the
drive system and the operator platform. If the
area is occupied(e.g.by an object or person),
lowering is stopped. Protect operator's safety.
The truck is equipped with deadman switch,
only by pressing the switch can the truck
be operated, which has greatly reduced the
possibility of misuse by the operator.