24
GB
Child lock / Operation lock
You can lock the control panel with the individual 4-digit pin code in order to prevent the unau-
thorized access.
In order to lock the display go to the settings
menu, select the
symbol and touch it again
shortly to enter the settings. A sub-menu win-
dow with „----“ and a numeric pad will open. Give
in your personal pin code using the numeric pad
and confirm the setting with
. Use “C” button
for corrections.
After the confirmation the display will return to
the start screen and the unit is now locked.
For safety reasons it is still possible to switch off the heater (interrupt active heating) and to switch
the light while the unit is locked. All other functions will be locked.
By an attempt to operate the control panel a pin code prompt will appear.
To unlock the unit touch e.g. the on/off button in order to call the pin code prompt. Now give in
your pin code. The unit is now unlocked.
!
How to reset the pin code by a locked unit
Touch the on/off or the settings symbols to launch the pin code prompt window.
Touch the display shortly in the top left corner. The four hyphens „----“ will turn for approx. 0,5 sec
into „****“ signs. Now quickly press the
button. The unit will be unlocked and the display will
return to the start screen.
Heating time
Here you can set the desired heating time duration for your sauna bath.
By private use the max. heating time is limited to 6 hours. By commercial use the max. heating
time may be limited to 6 hours, 12 hours or set to unlimited. This limitation may be set in hardware
during the installation and setup (jumper setting)
Touch the
symbol twice and set the required heating time in hours and minutes. This setting
will be then valid for every manual sauna switching in the current profile. You can of course stop
the heating earlier at any moment. Upon the setting the display will return to the previous menu.
After switching the sauna on the remaining heating time will be displayed as a countdown clock in
the bottom left corner. So you can check at a glance the remaining heating time.
Please notice that after a humid sauna operation the sauna dry program will be switched and the
heater will run in dry mode up to 30 minutes. The duration of the sauan dry program can be ad-
justed in the basis setup. Please contact your authorized dealer (installer).
The heating time setting is adjusted in +/- 1 minute steps from 00:01 (1 minute).
Set Code
15. October 2013
14:22:38
3
6
5
4
9
8
7
C
0
2
1
Summary of Contents for EmoTouch II +
Page 3: ...3 GB...
