Entes RG3-12C, Manual, Page: 27 / 41

POWER FACTOR CONTROLLER
RG3-12C/CS
26
The first parameter in the password menu is the parameter activation
menu(Pin ACt). According to this setting, password for the device menu
can be set “inactive” or “active”. Press the
“SET” button to enter this
menu.
SAUE
If you want to leave the setup menu without making any other changes,
press the
“ESC” button until “SAVE SEt yES” shows on the screen. If
you want to save the changes, press the “SET” button. If not, press the
“ESC” button.
If you did not activate the password before, enter the pin code as
“1234”
.
If you changed the password before, enter that password. Press
“SET”
button to change the password activation setting.
Note:
While entering the pin code, the blinking digit represents the digit
which will be set. Press the “UP/DOWN” buttons to increase/decrease
the value of the related digit. Press “SET” button to set the next digit or
press “ESC” button to set previous digit.
Using the “UP/DOWN” buttons, select the “Pin ACt” as “on” or “of” and
then press the
“SET”
button. If you are going to change another setting,
return to the menu by pressing the “SET” button. If you do not want to
set another parameter, press the “ESC” button.
In this menu, user password is activated. When the password is activated,
a pin code is always required before entering to the menu.
User password can be changed and activated in this menu. When the
password is activated, a pin code is always required before entering to
the menu.
Thus, user password prevents any change to the settings of the device
by unauthorized people. For this reason, a pin code with 4 digits must be
set and then it must be activated.
Note: Factory default value for pin code is “1234” and it is not activated.
3.12 Password Activation and Change Settings
3.12.a Pin Activation
Using the “UP/DOWN” buttons, find “Pin” menu.
Press
“SET”
button to enter the password menu.
Using the “UP/DOWN” buttons, select a parity option and press the “SET”
button. If you are going to change another setting, return to the menu by
pressing the
“SET” button. If you do not want to set another parameter,
press the “ESC” button.
SAUE
If you want to leave the setup menu without making any other changes,
press the
“ESC” button until “SAVE SEt yES” shows on the screen. If
you want to save the changes, press the “SET” button. If not, press the
“ESC” button.
Press the “SET” button for 3 sec. in order to enter to the menu.
3 sec.