Ethernet:
Avenue frames may be controlled by a Express Panel connected to a 10BaseT
Ethernet network. The IP Address for each frame in the network is set on the System
Control module in each frame or frames connected to the Ethernet network. The
Avenue backplanes have a standard RJ45 connector for Ethernet interface.
Each Avenue device on the Ethernet network must have a different IP Address,
including the Express Panel. The address for the frame is set using the Status menu
functions on the front of the 5030/35 Control Module in each frame or a Touch Screen
or Express Panel. Refer to the
Express Panel Networking
section for detailed
information.
Serial Control:
If using a serial interface connection from the Express Panel to remotely control a
frame (or series of frames connected via AveNet), connect a 9-pin D to 9-pin D cable
(pinout is shown in the pinout diagram below) from the
Serial Control
port on the
rear of the Express Panel to the serial port on an Avenue frame with a 5030/5035
Control module installed.
Power:
Connect the AC power adapter included with the panel to the power connection on the
Avenue Express Control Panel
Express Panel–7
Configuration Control Overview on Express Panel
Configuration Display
Control Knob
for changing
values in the configuration
display and also for moving
in and out of configuration
menus when pushed in.
Select Config
pushbutton
to enable configuration
User Level
pushbutton
(not active)
Load/Save
pushbutton
for defining channels.
Menu Select
arrow
pushbuttons to move in
and out of configuration
menu levels.
CLR
(Default) pushbutton
to return Channel parame-
ters to defaults.