CHANNEL SELECT CONFIGURATION AND OPERATION
To.configure and use the
Channel Select
pushbuttons to recall Video proc amp and Audio
levels controls for easy adjustment with the Express Panel knobs on the left of the panel,
refer to the instructions below. This functionality is best utilized on the 7500, 8400, and
8500 modules.
Channel Select Configuration
1. Enter the Configuration mode by selecting the
Select Config
pushbutton. It will
illuminate red to indicate you are now in Configuration mode.
2. Enter the
Choose Frame by Knob
selection and move the carat to the frame
containing the module you wish to use for the Video or Audio selection for a
channel.
3. Move the carat to the desired module and enter the module menus.
4. With the
Select Confi
g pushbutton still enabled, select the
Load Save
pushbut-
ton, then the
Video
pushbutton. Push a
Channel Select
pushbutton to assign the
Video parameters from the selected module in the Configuration display into this
selected channel.
When the Video parameters have been saved to a channel, the corresponding
Channel Select
pushbutton will illuminate green when pressed. The
Configuration Display will now show what module is assigned to the
Video
pushbutton and the Parameter display on the left of the panel will show the proc
amp controls (Video, Chroma, Hue, and Pedestal) for this module.
5. Now assign the Audio parameters to the same channel if desired. You must return
to the Configuration display and repeat the steps above to enter the same module
or choose another module in the list and assign the Audio parameters in the same
manner.
When the Audio configuration is complete, the The Configuration Display (shown
below) will now show what module is assigned to the
Audio
pushbutton and the
Parameter display on the left of the panel will show the audio level controls (Ch 1,
Ch 2, Ch 3, and Ch 4) for this module.
6. Do this for each
Channel Select
pushbutton.
Avenue Express Control Panel
Express Panel–1
7