Code: I.H4.V10.3003
Installation and Maintenance Manual
Version: 07
29 / 66
Ennera Energy and Mobility, S.L.
This document contains confidential information which is property of Ennera Energy and Mobility, S.L. The copy, transmission or use by other people, of the whole document or
part of its contents, is not allowed without written permission from Ennera Energy and Mobility S.L.
6.
Connect the anemometer wires to
the X10 connector (A upper row and B
lower row)
Power supply 12V (+ white):
X10 - A4
Power supply 12V (- brown): X10 - B4
If the wind turbine is going
to be installed in an icing
area, install an
anemometer with heating.
Heating connection:
Power supply 230V (green):
X8-L1
Power supply 230V (yellow): X8-N
7.
Once all cables are connected,
tighten the 4 cable glands to have a
good sealing of the cables.
8.
If the sealing is not good, use a
sealing paste to fill the gaps.
If there is any gap for air
inlet, humidity can damage
the converter.
9.
Locate again the earth connection
cable (faston) in the front cover of the
converter and close it with the 10 M4x8
allen screws.
10.
Push the emergency button to brake
the wind turbine until the start-up.
