SETTING UP YOUR EBIKE 5
BILLY EBIKE USER MANUAL
B. REMOVE TIES & PADDING
Using a 6mm allen wrench, undo the four bolts at the
top of the head stem and remove the top piece.
Pointing the handlebars with the levers facing down,
place the knurled center section of the bar in mounting
point of the head stem.
C. INSTALL HANDLEBAR
The installation is made easier if the display is rotated
forward. If the display is secured and will not rotate eas-
ily, loosen the securing bolts slightly with a 3mm allen
wrench.
Replace the previously removed top piece and install
the four bolts by hand to ensure correct installation.
Slightly tighten each bolt at opposite ends (e.g. 1, then
4, then 2, then 3) a little at a time to ensure even pres-
sure is applied across the top piece.
Just before the bolts are fully tightened, adjust the han-
dlebar so that the vertical bars are in line with the forks
and the brake levers face forward.
Tighten the four bolts to ensure a secure connection of
the handlebar to the head stem.
Straighten the handlebar so that a forward facing han-
dlebar coincides with a forward facing front tire, then
secure by removing the rubber cover and tightening the
top cap bolt.
Using scissors, carefully cut and remove zip ties and
padding, ensuring you do not mark or damage the bike
or its components.
USE OF SCISSORS OR BLADES RISK
SCRATCHING OR HARMING YOUR
EBIKE. TAKE EXTREME CARE.
BE CAREFUL NOT TO OVER TIGHTEN
AS EXCESSIVE FORCE MAY DAMAGE
THE HEAD STEM THREADS.
