SETTING UP YOUR EBIKE 13
BILLY EBIKE USER MANUAL
Twisting the stopper in an anti-clockwise direction re-
duces the amount of preload.
Twisting the stopper in a clockwise direction increases
the amount of preload.
Your Billy ebike comes equipped with either a belt or
chain drive system. It is important to maintain belt/chain
tension to ensure optimum energy is being transferred
from the crank to the rear wheel.
In order to correctly adjust the drive tension, you must
first locate and loosen both of the rear axle nuts using
an 18mm spanner.
10. DRIVE SYSTEM
Next, locate and adjust the tensioner accordingly.
For increased tension, turn the tensioning nut in a
clockwise direction.
For reduced tension, turn the tensioning nut in an an-
ti-clockwise direction.
Once you have achieved the desired amount of tension,
tighten both the rear axle nuts using an 18mm spanner.
When setting up your Billy ebike for the first time, we
recommend that you charge the battery to full over-
night. This allows the battery to balance.
As you use the battery, when possible try to use the
battery until it is completely empty and then charge it
until it is completely full before using it again. Fully cy-
cling the battery like this should help extend the life of
the battery.
Your battery can be charged either on or off the ebike.
To charge on the ebike, locate and peel open the rubber
door to expose the battery’s ports and power button.
11. BATTERY
ONLY ATTEMPT TO ADJUST REAR
PRELOAD IF YOU ARE EXPERIENCED
WITH SUSPENSION TUNING. OTHER-
WISE, PLEASE CONSULT A QUALIFIED
BICYCLE MECHANIC.
ONLY ATTEMPT TO ADJUST YOUR
DRIVE SYSTEM IF YOU ARE EXPERI-
ENCED WITH CYCLE MAINTENANCE.
OTHERWISE, PLEASE CONSULT A
QUALIFIED BICYCLE MECHANIC.
ONLY OPERATE YOUR BATTERY AND
CHARGER BETWEEN 50 DEGREES
FAHRENHEIT (10C) AND 80 DEGREES
FAHRENHEIT (27C) TO AVOID COM-
PONENT FAILURE AND MINIMIZE THE
RISK OF INJURY.
