telltale signs that feedback is swelling and consequently can't take measures to
suppress it. For this reason, make an extra effort to be careful when the
is
activated: Before you approach the amp and speaker cabinet with your guitar in hand,
turn the guitar's volume knob to the far left position (to 0 so that no signal is audible)
to prevent the pickups and speakers from interacting!
Connect
to a signal processor's input/return jack using the shortest
possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled
remotely (: on/off) via a footswitch connected to jack 20 (for details refer to chapter
20) or via the ENGL Custom Footswitch Z-9 (refer to chapter 19 for details). In the
signal path, the
located post preamp and pre the two power amp Master
knobs.
Connect the
input to a signal processor's output/send jack using the shortest
possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled
remotely (: on/off) via a footswitch connected to jack 20 (for details refer to chapter
20) or via the ENGL Custom Footswitch Z-9 (refer to chapter 19 for details). In the
signal path,
located post preamp and pre the two power amp Master
knobs.
FX mix control for the
. When the knob is set to
, the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to
when this loop is not in use! S
4 ohms speaker output jacks, internal connected parallel. For diverse cabinet options
!
8 ohms speaker output jacks, internal connected parallel. For diverse cabinet options
!
16 ohms speaker output jack. For diverse cabinet options
!
Never operate the power amp without a
sufficient load, otherwise you may damage or destroy it! Always check the connected
cabinets' impedance to confirm it matches the amp's output impedance! For example,
if you are connecting a cabinet to one of the two 8-ohms output, make sure the
Noise Gate
FX Loop
Dry
Dry
abinet options
abinet options
abinet
options
25 FX Loop Send
26 FX Loop Return
27 FX Loop Balance
NOTE:
28, 29 Poweramp Output, 4 Ohms Parallel
30, 31 Poweramp Output, 8 Ohms Parallel
32 Poweramp Output, 16 Ohms
IMPORTANT NOTE, please read and heed:
the FX Loop output
FX Loop is
FX Loop
FX Loop is
ettings between the 9 and 3
o'clock position reduce the signal level.
see the chapter
on page 15
see the chapter
on page 15
see the chapter
on page 15
C
C
C
14
