Internet Connection
Type
Select
Static IP
to begin configuration of the Static IP connection.
Account Name
Enter the account name provided by your ISP.
Domain Name
Enter the domain name provided by your ISP.
MTU
Specify the Maximum Transmit Unit size. It is recommended you
accept the default setting of
Auto
. Otherwise, packets will be
fragmented downstream if the MTU is set too high or too low,
which impacts network performance. In extreme cases, an MTU
setting that is too low can prevent the ENH200 from establishing
some connections.
IP Address
Enter the WAN port IP address.
IP Subnet Mask
Enter the WAN IP subnet mask.
Gateway IP Address
Enter the WAN gateway IP address.
Primary DNS
Enter the primary DNS IP address.
Secondary DNS
Enter the secondary DNS IP address.
Discard Ping on WAN
Check to
Enable
to recognize pings on the ENH200 WAN
interface or
Disable
to block pings on the ENH200 WAN
interface. Note: Pinging IP addresses is a common method used
by hackers to test whether the IP address is valid. Blocking pings
provides some extra security from hackers.
Accept / Cancel
Click
Accept
to confirm the changes or
Cancel
to cancel and
return previous settings.
Clicking
Accept
does not apply the changes. To apply them, use
Status > Save/Load
(see
section 4.1).
