ENFORCER Wireless Video Door Phone
SECO-LARM U.S.A., Inc.
13
Operating the Wireless Video Door Phone (continued):
Intercom feature with two monitors:
1.
Make sure both monitors are powered ON.
2.
Press the "OK" or "Power" button to turn the monitor's display on.
3.
Press the "OK" button to call the other monitor.
4.
To accept the call, the other monitor's user must press their "OK" button.
5.
Press the "OK" button again when finished with the call.
NOTE: The intercom feature will automatically timeout after 60 seconds.
Intercom feature with three monitors:
1.
Make sure all monitors are powered ON.
2.
Press the "OK" or "Power" button to turn the monitor's display on.
NOTE: Each paired monitor will have an identification number in the top left corner (1, 2, or 3).
3.
Press the "Up" button to call the next highest ID monitor.
4.
Press the "Down" button to call the next lowest ID monitor.
If monitor 1 is calling monitor 2, the user would press the "Up" button.
If monitor 3 is calling monitor 2, the user would press the "Down" button.
If monitor 3 is calling monitor 1, the user would press the "Up" button.
5.
Press the "OK" button when finished with the call.
Resetting the Camera and Pairing a First Monitor:
Communicating between monitors
NOTE: The Wireless Video Door Phone system can be set up with up to 2 cameras and 3
monitors. If multiple monitors are set up, then the system can be used as an intercom
between each monitor. To pair additional monitors see "Pairing Additional Monitors or
Cameras," pg. 14.
NOTE: By default, the monitor in the DP-266-1C3Q Complete Kit is paired with the camera.
These instructions apply to resetting the camera and monitor system.
1.
Put the camera into pairing mode:
a.
Remove the camera from the bracket.
b.
If the tamper alarm is active then the alarm will begin to sound.
i.
Disconnect power from the camera by removing the battery and disconnecting the
power wiring.
ii.
Replace the battery.
c.
Use a paper clip or other small object to press and hold the camera's reset button for
three to four seconds. A single beep indicates the camera is in pairing mode.
NOTE: The camera will remain in pairing mode for ~15 seconds before
automatically exiting.
2.
Pair the first monitor to the camera:
a.
Select "Match code" from the "Pairing" option in the "Settings" menu.
b.
The monitor will display "Success" and the monitor and camera will beep three times.
