Enerzone Euromax, Installation And Operation Manual

Page: 51 / 100

Euromax Pellet Stove Installation and Operation Manual
51
NOTE: IF YOU NEED TO CONTACT YOUR DEALER OR TECHNICAL SUPPORT, MAKE
SURE TO HAVE THE MODEL OF YOUR STOVE AND THE SERIAL NUMBER ON HAND.
(THEY CAN BE FOUND ON THE CERTIFICATION LABEL INSIDE THE HOPPER LID).
9.1 Validating Status
When using your stove, you can validate at any time, the status of any of the following
components:
-
Electronic components (low power rated)
o
F160 (security heat sensor)
o
L-250A (security heat sensor)
o
Pressure switch (security sensor)
o
Hopper switch (mechanical security sensor)
o
Thermostat (temperature regulator device)
-
Electrical components (high power rated)
o
Igniter (heater)
o
Combustion blower (will feed fire with fresh air)
o
Convection blower (will send hot air into the room)
o
Exhaust blower (will extract combustion gas out of the stove)
o
Auger motor 1 (located under the hopper)
o
Auger motor 2 (will feed the fire with pellets)
WARNING: RISK OF ELECTRICAL SHOCK. IF YOU NEED TO MANUALLY TEST,
MANIPULATE OR REPLACE ANY COMPONENTS, THE STOVE NEEDS TO BE
DISCONNECTED FROM THE WALL OUTLET.