17
EWB-MOTOM3-BK
USER’S MANUAL
ASSEMBLY INSTRUCTIONS
Your Moto M3 may come in three different states:
a. 95% assembled - you only need to install the mirrors and the cargo box.
b. 90% assembled - you need to install (a) the front wheel.
c. 85% assembled - you need to install (b) the handle bar and some plastic elements.
All instructions for (a), (b) and (c) are described below with pictures.
HANDLE BAR
Insert the top part of the handlebar into the handlebar post, as shown on the picture.
Locate the attachment bolt, nut and spacer, and insert the bolt into the hole from back to front.
Slide the spacer into the bolt with the round side facing the handlebar post.
Screw the nut on top and tighten it.
Once attached, the handlebar should look like the one in the picture.
FRONT PANEL - MOTO M3
Locate the front panel and connect the head light wire plug to the corresponding
plug at the front of the bike, as shown on the picture. Insert the plastic
fins on the front panel in the corresponding channels on the base (see picture)
and slide upwards until the holes on the back black cover match the screw holes
on the cover. Insert the screws into the holes on the black back cover and
screw them onto the front cover.
MOTO M3
Locate the front panel and connect the head light wire plug
to the corresponding plug at the front of the bike, as shown on the picture.
Locate the front hole in the middle of the panel and use the short bolt to attach
it to the body. Locate all attachment points on the cover, insert the screws into
the holes on the black cover and screw them onto the front cover.
A. FRONT WHEEL WITH DRUM BRAKE
The front end of the bike is attached to the crate with a bolt.
Unscrew the nut carefully and remove the axle.
Locate the front wheel and insert the break mechanism into it.
Insert the axle in the swing arm of the front fork and then in the break
drum and the wheel. Make sure to apply the spacer before inserting
the axle in the other side of the fork. Tighten the nuts firmly.
INSERTING "U" NUTS
CONNECTING HEAD LIGHTS
SPACER
WARNING
DO NOT MAKE ANY ALTERATIONS OR MODIFICATIONS TO THE MOTOR OR ADD ANY PARTS
THAT HAVE NOT BEEN AUTHORIZED BY THE MANUFACTURER, APART FROM THOSE
MENTIONNED IN THIS MANUAL OR THOSE REQUIRED BY LAW. DO NOT REMOVE ANY
REFLECTORS, LIGHTS OR OTHER STANDARD EQUIPMENT AS DOING SO WILL VOID
YOUR WARRANTY.
All authorized replacement parts are listed on the enclosed parts list. If you are unsure, please call your local dealer.
