EndRun FDC3302, User Manual

Page: 34 / 46

F D C 3 3 0 2 U s e r M a n u a l 24
A P P E N D I X C
25 F D C 3 3 0 2 U s e r M a n u a l
N E T W O R K P O R T O P T I O N
netreset
This command will reset the network port. This is needed after the network parameters are changed.
For example, if you change from DHCP on to off then you will need to reset the network port.
Command:
netreset
Chassis response:
Resetting network port.......
netsnmp
This command enables or disables SNMP. Syntax is: netsnmp = x where x is on or off.
Set:
netsnmp=on
Chassis response:
OK
Query:
netsnmp
Chassis response:
on
Factory default setting:
off
netsnmpro
This command sets the SNMP read-only community string. The community string must be at least 8
and less than 32 characters. Characters must be alphanumeric or the underscore ‘_’. Entering con-
trol-C will quit without changing the community string. There is no query mode for this command.
Set:
netsnmpro
Chassis response: System prompts for the SNMP read-only community string.
Factory default password:
fdc_user
netsnmprw
This command sets the SNMP read-write community string. The community string must be at least
8 and less than 32 characters. Characters must be alphanumeric or the underscore ‘_’. Entering con-
trol-C will quit without changing the community string. There is no query-mode for this command.
Set:
netsnmprw
Chassis response: System prompts for the SNMP read-write community string.
Factory default password:
endrun_1